Rena XPS-ProFeed Shuttle - Manual (Page 19)

13
Section 4 - Maintenance
General Cleaning
The XPS-PROFEED SHUTTLE must be cleaned regularly of accumulated paper dust and ink.
Depending on the types of media that are run, paper dust may accumulate within the printer and
on the transport.
If you are uncomfortable performing these tasks, please contact your dealer to schedule service.
WARNING
THE XPS-PROFEED SHUTTLE IS A PRECISION MACHINE THAT
SHOULD BE CLEANED REGULARLY TO INSURE MANY YEARS OF
SERVICE. BEFORE PERFORMING ANY MAINTENANCE DISCONNECT
THE MACHINE FROM ITS POWER SOURCE!
Unplug the feeder from power receptacle and remove the covers.
The internal areas are best cleaned with a vacuum that has a soft brush attachment to help
loosen the dust particles. Take care not to damage the PC Boards or electrical wiring.
The exterior of the machine may be cleaned with any standard household cleaner which is non-
abrasive and does not contain plastic harming solvents.
Cleaning the Media Sensor
Periodically check the media sensor located just below the two large
forwarding rollers. The sensor should be clean and free of
accumulated paper dust. Use a vacuum with a soft brush attachment
or dry compressed air to remove the dust.
NOTE: Image of media sensor is shown with exit cover removed;
for identification purposes only.
Cleaning Feed Rollers
Feed Rollers can become glazed with paper lint and ink from media. Clean regularly with a mild
abrasive household cleaner on a damp cloth. Avoid using solvents on Rubber Rollers.
CAUTION
UNPLUG THE FEEDER FROM THE POWER RECEPTACLE BEFORE
PERFORMING ANY MAINTENANCE ON THE FEEDER.
NEVER SPRAY OR POUR CLEANERS DIRECTLY ON OR INTO THE
XPS-PROFEED SHUTTLE. EXCESS LIQUID COULD HARM
ELECTRONIC PARTS. ALWAYS DAMPEN A RAG WITH THE
CLEANER AND APPLY IT TO THE PARTS TO BE CLEANED.