RGBLink New Driver User Manual - Manual (Page 46)

New Driver User Manual 46
follows:
1. Take a piece of sending card, and remove the stand of the LEDs, weld on a 2*2 pin,
2.54 mm pitch row needle, as shown below (applicable to LINSN, Colorlight T7 and Nova
sending card).
2. Take another sending card and a 3P double line (30 cm long, 2.54 pitch), cut one side
of the stand, and weld to the back of sending card, as shown in the figure below:
Note: Step 2 is only applicable for Linsn sending card.
3. After welding, connect the other end of 3P double line to the red box area of MCU
board, as shown in the figure below: