Daewoo DP-HG22 - Manual (Page 8)

7
INSTALLING THE WALL FRAME SET A ON THE PLASMA DISPLAY
HOW TO DISPOSE OF THE PLASMA MONITOR WRAPPER
HOW TO INSTALL FRAME SET A ON THE UNIT
.
First discard the wrapping band and
raise the top box to open.
.
Afterwards, dispose of the Styrofoam
and remove the vinyl covering.
.
To avoid unwanted marks on the unit, place
a protective covering over the surface you
will be working on and lay the plasma display
as shown in the picture below.
.
When securing frame set A to the plasma display, make sure that they match the holes correctly.
.
If holes are matched incorrectly, installation will not be successful.
.
Place frame set A on the left and right
side of the unit and use the enclosed
screws (M5) to secure them tightly.
(left and right 4 each)
1
2
Note