Sensoray 2224 Linux - Manual (Page 16)

S2226_CID_AUDOUT_STEREO_MUTE_L: mute for stereo left channel
S2226_CID_AUDOUT_STEREO_MUTE_R: mute for stereo right channel
Audio Meter Controls:
S2226_CID_AUDMTR_CHANNEL: audio meter channel selection. 0-LineIn, 1-
MpegOut,2-SDI-in
S2226_CID_AUDMTR_LEVEL_L: peak level for left channel (23 bits unsigned)
S2226_CID_AUDMTR_LEVEL_R: peak level for right channel (23 bits unsigned)
S2226_CID_AUDMTR_LEVELDB_L: level for left channel. Value is dB x 10. -2048(-
20.48 dB) to 0 (0dB).
S2226_CID_AUDMTR_LEVELDB_R: level for right channel. Value is dB x 10. -2048(-
20.48 dB) to 0 (0dB).
S2226_CID_AUDMTR_HOLDREL: audio meter hold release. 1-force release of 'held'
output. 0-allow holding of highest db value per the set hold time
S2226_CID_AUDMTR_HOLDTIME: audio meter hold time. 0-(No Hold 1ms update), 1-
(0.5s), 2-(1.0s), 3-(1.5s), 4-(2.0s), 5-(2.5s), 6-(3.0s), 7-(Hold high always).
S2226_CID_AUDMTR_HOLD_L: audio meter hold value left channel. Same units as
LEVELDB values.
S2226_CID_AUDMTR_HOLD_R: audio meter hold value right channel. Same units as
LEVELDB values.
S2226_CID_AUDMTR_CLIP_L: whether left channel was clipped
S2226_CID_AUDMTR_CLIP_R: whether right channel was clipped
S2226_CID_AUDMTR_TEST: 0-(Off), 1-(0dB), 2-(-6dB), 3-(Clip). Test mechanism for
the audio meter. Default is off.
Extra Codec Controls:
S2226_CID_CODEC_PROGRAM_NUMBER: change the default transport stream
program number. Default 1. Allowed values 1-0x1ffe
1