User controls, Codec controls, Audio input controls – Sensoray 2224 Linux User Manual
Page 8
User Controls:
•
Brightness, Contrast, Saturation, Hue
•
Audio Mux MPEG in: Same as audio input. Line-In, Test Tone, SDI
•
Audio Mux Line Out: Selects the output source for the audio line-out output
connection. Line-In, Mpeg OUT(for decode) or SDI-In.
•
Audio Mux SDI Out: Selects the output source for the audio output over SDI. Line-
In, Mpeg OUT(for decode), Test Tone, or SDI-In.
Codec Controls:
•
Stream Type: Displays as MPEG-2 Transport Stream. Stream type is the container.
The codec is H.264 inside the MPEG transport stream. Transport stream is defined
in the MPEG-2 standard, which may cause confusion.
•
Audio Sampling Frequency: 48Khz
•
Audio Encoding: MP2
•
Audio Layer II Bitrate: 128kbps, 160kbps, 192kbps, 224kbps, 256kps
•
Video Encoding: H.264 (AVC). The video codec in use.
•
Video GOP Closure: Whether GOPs are open or not
•
Video Bitrate: 1000-20000Mbps. It is recommended to use 2Mbps as a minimum
for HD sources.
Audio Input Controls:
•
Audio In AGC On Left: Turns on AGC for left audio input channel
•
Audio In AGC On Right: Turns on AGC for right audio input channel
•
Audio In AGC Gain Left: Sets AGC gain for left audio channel. The range for the gain
is from 0 – 118 in steps of 0.5dB. A setting of 0 would be no gain. A setting of 118
would be 118x0.5db = 59.0dB. This setting does not apply if AGC is turned off.
•
Audio In AGC Gain Right: Sets AGC gain for right audio channel. The range for the
gain is from 0 – 118 in steps of 0.5dB. A setting of 0 would be no gain. A setting of
118 would be 118x0.5db = 59.0dB. This setting does not apply if AGC is turned off.
•
Audio In Gain Left: Sets non-AGC gain for left audio channel. The range for the gain
is from 0 – 118 in steps of 0.5dB. A setting of 0 would be no gain. A setting of 118
would be 118x0.5db = 59.0dB. This setting does not apply if AGC is turned on.