Operation – Desa GA9150A User Manual
Page 10
www.desatech.com
901053-01J
10
OPERATION
Continued
OPTIONAL REMOTE
OPERATION
Note: All remote control accessories must
be purchased separately. Follow instructions
included with the remote control.
NOTICE: you must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 8.
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Slide
the selector switch to the REMOTE position.
Note: The burner may light if hand-held remote
was on when selector switch was last turned
off. You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON/OFF SERIES (MOdEL HRC100)
Hold the control button on the hand-held
remote until burner turns on. Hold the control
button again until burner turns off.
TO LOCK press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Figure 19 - On/Off Hand-Held Remote
Control unit HRC100