Skutch Electronics AS-101 - Manual (Page 6)

Al Sandige Page 6 12/05/01
Turning on/off
The AS-101 can be turned ON and OFF both
locally and over the phone. The AS-101 will tell you
it is off by making a short beep about 2 seconds after
the answering machine answers.
To turn the AS-101 off when you are in front of
the unit, press the * on the AS-101 keypad while the
display shows IDLE STATE.
To turn the AS-101 on when you are in front of
the unit, press the # on the AS-101 keypad while the
display shows IDLE STATE.
To turn the AS-101 off over the phone, do the
following:
1) Call your answering machine.
2) When you get to the spot in your message where
you leave a message, enter the access code for
the AS-101.
3) The AS-101 will beep four times.
4) Enter * # to change between ON and OFF. If the
AS-101 is ON, this code will turn it OFF and
you will hear the OFF tone; if the AS-101 is
OFF, this code will turn it ON.
5) Enter * * to make the AS-101 hang up.
•
Changing Access Code
1) While the display shows IDLE STATE, enter
999.
2) Enter 1.
3) Enter your new three digit access code. NOTE:
The Access Code for the AS-101 must NOT be
the same as the code for your answering
machine.
4) Enter #, then press the RESET button.
Resetting The
Unit
The AS-101 can be RESET both locally and
over the phone.
To reset the AS-101 when you are in front of it,
do the following:
1) Push and hold down the 1 on the AS-101
keypad.
2) While you are still holding the 1 down, press
then release the RESET button.
3) Now release the 1 button.
To reset the AS-101 over the phone, do the
following:
1) Call your answering machine.
2) Enter the RESET CHR two times. If the RESET
CHR is *, then enter * *.
3) The AS-101 will stay reset throughout the call.
• Change Remote Reset
digit
1) While the display shows IDLE STATE, enter
999.
2) Enter # # # 1.
3) Enter the new Reset Character you want to use.
You can use 0 through 9 or *.
4) Enter #, then press the RESET button.
Enter Alert
Numbers
The AS-101 can hold 6 different number strings
from 7 to 29 digits long each. To put your alert
phone numbers into the AS-101, do the following:
1) While the display shows IDLE STATE, enter
123.
2) If the top line in the display doesn't show
<1>CHANGE - 1 -- , then press #.
You are now at the first memory spot. These
memory spots (6 in all) hold the phone number
strings to dial. You can move down through memory
by pressing the #. After the last memory spot (the
6th phone number), the AS-101 returns to IDLE
STATE.
• Change An Alert Number
1) Go to the memory spot for the phone number
you want to change, then press 1.
2) Enter the new phone number string. NOTE: The
phone number must be entered exactly like you
would dial it from that phone line; i.e. if you
wouldn't dial a 1 or the area code, then you
shouldn't enter a 1 or the area code.
3) Enter #.
4) Enter the number of minutes to wait before
dialing the next number. You can enter any
value from 0 to 99. A value of 0 will make the
AS-101 go to the next number immediately.
5) Enter #.