Smart Avi SignagePro - Manual (Page 93)

7. Screen Configuration 89
(c) 2010 SmartAVI
§ 7.2 Installing and Removing Fonts
1. Logging into the configuration console.
· Once you turn on the client, you are greeted with the SignagePro Splash Screen.
· After the kernel initiates you are given approximately 15 seconds to press ‘F2’ and enter the
configuration console.
figure 7.2.1
2. Once you are at the configuration console you are given four options.
These options are as follows:
· If you want to configure xorg run: axorgcfg
This is where you configure your monitor and resolution settings.
· To install fonts from usb flash disk run: installfonts
Typing installfonts into the command line will install fonts from your USB flash drive.
It is important to note that if you use specialized fonts in your presentations, you will need to
install those fonts onto the SignagePro client for your presentation to display
properly.
· To remove installed fonts run: removefonts
Type ‘removefonts’ into the command line and press ‘Enter’ to remove any fonts that are no
longer being used.
· To reboot run: reboot
Typing ‘reboot’ into the command line reboots the system and brings you back to the main