Teac PD-D2610 - Manual (Page 12)

12
In the stop mode, press the PROGRAM CHECK button
repeatedly. The track and program numbers will be shown on
the display.
To check the programed order
Programed Playback
< Up to 32 tracks can be programed in the desired order.
< If the shuffle mode is on, the PROGRAM button does not
work.
Press the PROGRAM button in the stop mode. 1
“PROGRAM” lights on the display.
If you want to select a track/file in another disc, press
the corresponding DISC NO. button (1-5). 2
Press the numeric button to select a track or file. 3
Press the PROGRAM button to enter your selection. 4
Repeat steps to to program more tracks/files.
< If you made a mistake, press the CLEAR button. The last
programed number will be deleted.
< Up to 32 tracks/files can be programed.
4 2
< Before you press the numeric buttons, “A” is displayed
instead of the track/file number. If you press the PROGRAM
button without pressing the numeric buttons, you can
program a whole disc.
You can also use the SKIP buttons (.//) to select a
track.
< If the unit has not yet detected the contents of the disc, you
can not enter 3-digit numbers with the numeric buttons. In
this case use the SKIP buttons (.//).
< You can not also enter numbers other than those detected as
specifying tracks/files in the disc.
When programing has been finished, press the PLAY
button to start programed playback. 5
When playback of all the programed tracks has finished, or if
one of the following buttons is pressed, the programed
playback stops:
STOP, OPEN/CLOSE
But the programed contents aren’t lost. You can return to the
programed playback by pressing the PLAY button.
< If the power is turned off, the programed contents will be
erased.
< When in the program mode, the following buttons don’t
work:
SHUFFLE, DISC NO., DISC SKIP
disc number program number
track/file number
1
2
3
5
4