Teac PD-H600 - Manual (Page 17)

17
ENGLISH
To delete a track from the program
While playback is stopped, press the PROGRAM button repeatedly
until the track number to be deleted appears on the display, then
press the CLEAR button.
The selected track is deleted from the program and the next track
is displayed.
< If you hold down the CLEAR button for more than 3 seconds, all
the tracks will be cleared.
To add a track to the program
While playback is stopped, press the PROGRAM button repeatedly
until the program number that you want to insert a track appears
on the display. Then select a track using the numeric buttons.
< When you want to add a track to the end of the program, press
the PROGRAM button repeatedly until “P-end” appears on the
display. Then select a track using the numeric buttons.
To clear the program
While playback is stopped, press the PROGRAM button, then
press the stop button (H).
< When you press one of the following buttons, the program is also
cleared:
open/close (L),
STANDBY/ON on the remote control unit,
POWER
Each time you press the DIMMER button, the display changes as
follows:
NORMAL (Normal)
DIMMER (Dimmed)
LIGHT OFF (Display off)
Note
< This setting is not memorized when the unit turns standby/on.
The next time the unit is turned on, the display is illuminated as
normal.
< When the unit is operated during the setting is “LIGHT OFF“, the
display turns normal briefly and will turn off again.
< The display is turned off about 5 seconds after the last operation
regardless of the dimmer setting, if Tone Direct is active on the
AG-H600 series receiver linked with this unit through the system
control function.
Dimmer