Teac PD-H600 - Manual (Page 5)

5
ENGLISH
Read this before attempting any operations.
< As the unit may become warm during operation, always leave
sufficient space around the unit for ventilation.
< The voltage supplied to the unit should match the voltage as
printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
< Choose the installation location of your unit carefully. Avoid
placing it in direct sunlight or close to a source of heat. Also
avoid locations subject to vibrations and excessive dust, heat,
cold or moisture.
< Do not place the unit on an amplifier/receiver.
< Do not open the cabinet as this might result in damage to the
circuitry or electrical shock. If a foreign object should get into the
unit, contact your dealer or service company.
< When removing the power plug from the wall outlet, always pull
directly on the plug, never yank the cord.
< To keep the laser pickup clean, do not touch it, and always close
the disc tray.
< Do not attempt to clean the unit with chemical solvents as this
might damage the finish. Use a clean, dry cloth.
< Keep this manual in a safe place for future reference.
During playback
During playback, the disc rotates at high speed. Do not lift or
move the unit during playback. Doing so may damage the disc
or the unit.
When moving this unit
When moving or packing the unit, be sure to remove the disc
and close the disc tray. Then, turn off the power and disconnect
the power cord. Moving this unit with the disc loaded may result
in damage to this unit.
Before Use
Beware of condensation
When the unit (or a disc) is moved from a cold place to a warm
place, or used after a sudden temperature change, there is a
danger of condensation: vapor in the air could condense on the
internal mechanism, making correct operation impossible. To
prevent this, or if this occurs, leave the unit for one or two hours
with the power turned on. Then the unit will stabilize at the
temperature of its surroundings.
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or
use diluted neutral cleaning liquid. Be sure to remove any fluid
completely. Do not use thinner, benzine or alcohol as they may
damage the surface of the unit.