Operation basics, 3 − menu operation – Teac CD-RW900MKII User Manual
Page 16
16
TASCAM CD-RW900MKII
3 − Menu operation
Operation basics
1. Select the desired menu option.
Press the
MENU
key on the front panel or remote
control to call up the desired menu. The menu
option PLAY will be shown on the display at first.
Front panel operation: Rotate the
MULTI JOG
dial
to select the desired menu option, then push the dial
to confirm.
Remote control operation: Use the
SKIP
key to
cycle through the different menu options, then press
the
ENTER
key to confirm.
The sub-menu option screen of the selected menu
will be displayed.
If the PLAY menu option is selected, the sub-menu
option shows up like this:
NOTE
Return to the menu option selection screen, press the
ESCAPE key on the front panel or the CLEAR key on
the remote control.
2. Select the desired sub-menu.
Front panel operation: Rotate the
MULTI JOG
dial
to select the desired sub-menu, then push the dial to
enter the selection.
Remote control operation: Use the
SKIP
key to
select, then press the
ENTER
key.
The menu item screen of the selected sub-menu will
appear. If the sub-menu PLAY MODE is selected,
the menu item shows up like this:
NOTE
To return to the sub-menu option selection screen,
press the ESCAPE key on the front panel or the CLEAR
key on the remote control.
3. Setting the desired menu item or value.
Front panel operation: Use the
MULTI JOG
dial to
select the desired menu item or value. Pushing the
dial enters and exits menu mode.
Remote control operation: Use the
SKIP
key.
Pressing the
ENTER
key confirms and exits menu
mode.
NOTE
Some menu options exist for confirmation purposes
only, and the setting cannot be changed.
4. How to exit menu mode after setting (or confirma-
tion), during menu option display.
Front panel operation: As well as pushing the
MULTI JOG
dial, you can use the
MENU
key to exit
menu mode.
Remote control operation: Press the
ENTER
key to
exit menu mode.
NOTE
The selected menu mode remains after power is
turned off, except the TEXT menu.
To reset all the settings and return to the factory setting,
use the F_PRESET sub-menu in the SYSTEM menu
option. It should only be used when a disc is not loaded.
When IR REMOTE is set to Disable, some functions can
not be operated using the remote control. On the other
hand, set to Enable allows any operation using the
remote control.