Teac IF-FW/DM - Manual (Page 4)


TASCAM IF-FW/DM Owner's Manual
O Installation
Installing the IF-FW/DM
1. Remove the five screws holding the blank
plate or card currently installed in Slot 1
then remove the plate or card.
2. Insert the IF-FW/DM into Slot 1, mak-
ing sure that the card edges slide into the
white plastic guide inside Slot 1. Push it
all the way in until it clicks and the card
back plate is flush with the mixer’s back
panel. Excessive force is not required - if
it does not click in easily, remove it and
start again with attention to the guides.
3. Replace the five screws to hold the card in
place.
NOTE
• The IF-FW/DM must be installed in to the
mixer’s Slot 1. It will not function in Slot 2.
• The following installation must be done with
the mixer’s power OFF and disconnected.
There is a series of jumpers on the IF-FW/
DM that set its operating mode. These jump-
ers must be in the correct position to operate
with a DM-3200 or DM-24, which com-
municate with the IF-FW/DM via different
operating modes.
Early IF-FW/DM cards shipped configured
for the DM-24. From the time of DM-3200
software version 1.20 availability, IF-FW/
DM cards began shipping configured for the
DM-3200.
Please confirm your card’s configuration
with the following pictures and instructions
then make any necessary changes before
installing the IF-FW/DM into your mixer.
NOTE
• The IF-FW/DM will not function if incor-
rectly configured for your mixer. Installing
an incorrectly configured card will not harm
anything.
• The IF-FW/DM must be installed in either
mixer’s Slot 1. It will not function in Slot 2.
Use commonly available needle-nose pliers
to carefully change the configuration of the
card as shown.
Picture 1 is IF-FW/DM Configured for a
DM-3200. Note that jumpers J11 through
J43 are across pin rows 2 and 3.
Picture 2 is IF-FW/DM Configured for a
DM-24. Note that jumpers J11 through J43
are across pin rows 1 and 2.
Configure For Your Mixer
J11 - J43
SDT : 1-2 (default)
LVDS : 2-3
Card edge
U43 U42 U41 U40 U26 U25 U24 U23 U35 U34 U32 U31 U18 U17 U16 U15
U39 U38 U37 U36 U22 U21 U20 U19 U30 U29 U28 U27 U14 U13 U12 U11
1
2
3
3
2
1
For DM-24
Picture 2
J11 - J43
SDT : 1-2 (default)
LVDS : 2-3
Card edge
U43 U42 U41 U40 U26 U25 U24 U23 U35 U34 U32 U31 U18 U17 U16 U15
U39 U38 U37 U36 U22 U21 U20 U19 U30 U29 U28 U27 U14 U13 U12 U11
1
2
3
3
2
1
For DM-3200
Picture 1