Regulatory information, Statement of conditions, Electronic emission notices – Teletronics EZStation2 User Manual

Page 50: Fcc information, R&tte compliance statement

Advertising
background image


Regulatory Information

Statement of Conditions

We may make improvements or changes in the product described in this documentation at any time. The information

regarding the product in this manual are subject to change without notice.

We assume no responsibility for errors contained herein or for direct, indirect, special, incidental, or consequential

damages with the furnishing, performance or use of this manual or equipment supplied with it, even if the suppliers

have been advised of the possibility of such damages.


Electronic Emission Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation.


FCC Information

The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:

The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in

accordance with instructions, may cause harmful interference to radio communication. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

overcome the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

- The equipment is for home or office use.


Important Note

FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for

an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm

between the antenna and your body and must not be co-located or operated in conjunction with any other antenna or

transmitter.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.


R&TTE Compliance Statement

This equipment complies with all the requirements of the Directive 1999/5/EC of the European Parliament and the

Council of 9 March 1999 on radio equipment and telecommunication terminal equipment (R&TTE)and the mutual

recognition of their conformity. The R&TTE Directive repeals and replaces in the directive 98/13/EEC. As of April 8,

2000.


Advertising