Q-See QSD42908 - Manual (Page 38)

QSD42908 User’s Manual
38
“Remote” (through network or internet):
PTZ Control: Remotely control PTZ cameras;
Record: Remotely start/stop manual recording;
Set parameters Setup: Remotely setup the DVR parameters;
Log: Remotely view the log on DVR;
Utilities: Remotely upgrade firmware, format the HDD, reboot the DVR and shut
down DVR, etc.
Talk: Client talks with DVR;
Alarm: Remotely control DVR alarm output;
Video Out: Remotely control DVR video output;
Com Control: DVR RS-232 transparent channel function.
.
MAC address
This MAC address is not the address of DVR but the PC that will access DVR. If
you setup this MAC address, only the PC with this MAC address can access this
DVR.
At PC end, in DOS prompt, you can use “ipconfig” command to get the PC MAC
address (6 bytes).
Delete user
In “User Management” interface, you can use
【б】 【в】keys to select a user, then
use
【à】 to move “Active Frame” to “Del” button, press【ENTER】, in the pop-up
confirmation dialog, press “Confirm” button to delete the selected user and return.
Press “Cancel” or
【ESC】to abort deleting. As shown in fig 5.7
Fig 5.7 Delete user