Q-See QSD42908 - Manual (Page 60)

QSD42908 User’s Manual
60
Alarm relay output setup
Step 1: In “Alarms” menu, use
【↑】【↓】keys to select one alarm output.
Step 2: Select delay time
The delay time is when the alarm ends, the alarm output will continue output time. The delay
time options are: 5 Seconds, 10 Seconds, 30 Seconds, 1 Minute, 2 Minutes, 5 Minutes, 10 Minutes
and Manual Stop. If you select the “Manual’ option, the alarm output will not stop until you press
the “Clear Alarm” button in the “Utilities” menu. The actual alarm output time is made up of
alarm input time and this delay time.
Step 3: Enter into alarm out schedule
You can set the schedule to make alarm output effective. Move the “Active Frame” to the
“Schedule” button on right side of “Alarm Out Time”, press
【ENTER】key to enter into the
corresponding schedule menu as shown in fig 5.25
Fig 5.25 Alarm out schedule
Step 4: Setup alarm out schedule
Like other schedule setups, you can set 4 time periods for one day and 7 days for one week.
When you finish setup, press the “Confirm” button to return to “Alarms” menu.
Step 5: Copy one alarm output parameters to other alarm outputs
In “Alarms” menu, you can copy parameters of current alarm output to other alarm outputs.