Q-See QSD42908 - Manual (Page 63)

QSD42908 User’s Manual
63
Remote Host IP and Port: If you set this IP and port, when there is an alarm and exception
happens, the DVR will send information to that host IP. The center with this IP can receive alarm
and exception information from the DVR. You can use SDK to develop this center software.
HttpPort: The port is for IE browser. The default value is 80. It can be modified.
Advanced setup: Move “Active frame” to “Advanced” then press “enter” to enter into the
configure interface as shown in fig 5.28
Fig 5.28 Advanced network setup
Advanced setup description:
NIC type: Default is “10M/100M Auto”, the other options are: 10M Half-Dup, 10M
Full-Dup, 100M Half-Dup and 100M Full-Dup.
IP server address: If DVR uses PPPoE function, it can get one dynamic IP address. If you
set DNS IP with one fixed Internet IP, the DVR will send some information such as DVR name,
DVR serial number, DVR current IP to that fixed IP address. We call that fixed Internet IP the
DNS IP. The DNS server with that fixed Internet IP address can receive DVR information and
use it to resolve DVR dynamic IP.
This IP server is special software, not the normal domain name server. You can use the
available SDK to develop this DNS software.
DNS IP : Get your DNS IP from your ISP . Fill in this item in order to get access to a remote
server with a domain name.
Multicast IP: It is one D-class IP address, from 224.0.0.0 to 239.255.255.255. If you do not
use the multicast function, you do not need to set this. Some routers will prohibit multicast
function in case of a network storm.