Thinklogical Velocitykvm T-4200 DVI Modules 4, 5, 8, 24 Manual - Manual (Page 9)

T-Series DVI Modules, Rev. C
9 October, 2012
2.5.1 Rear Panel Views
A selection of Velocity T-4200 Rear Panels in Transceiver, Receiver & Transmitter Configurations
2.6 Set-Up
2.6.1 Dry Contact Alarm
Dry contact alarms are located on the transmitter and receiver units. When there is an alarm condition
the relay is energized. An example of possible alarm causes might be over-temperature or a power
supply issue.
The dry contact alarm is a Form C contact with the following ratings:
Nominal Switching Capacity: 1 A 30 VDC
Max. Switching Power: 30 W DC
2.6.2 Firmware Upgrades
Firmware upgrades are available through Thinklogical. Please call for technical assistance at:
1-203-647-8700.