Tri Tool 201BA Beveler - Manual (Page 10)

10
TRI TOOL INC.
92-0631 : Orig. 960119
NOTE:
NOTE:
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the cutting head during the machining operations
are removed.
Verify that there is adequate grease in the gearbox.
Gears and Bearings are to be lubricated using a high string utility grease
(P/N 68-0020).
Grease
Disassembly of a power unit voids warranty, except when performed by a
TRI TOOL Inc. designated repair technician. (A letter of designation is
required.)
AIR MOTOR LUBRICATION
No direct maintenance is normally required on the Air Motor.
However, the air supply must flow through a filter/regulator/lubricator (FRL) unit or
separate units before arriving at the Air Motor.
The FRL unit must be maintained as required (frequency dependent on the basic air
supply) to keep the water trap drained, filter cleaned and the lubricator oil reservoir
filled so that a drop of oil every 2 to 5 seconds is flowing.