Tri Tool 201BA Beveler - Manual (Page 20)

20
TRI TOOL INC.
92-0631 : Orig. 960119
BASIC FEED RECOMMENDATIONS
Use very light feed for initial beveling or until a continuous cut is established.
This is very important for longer tool bit life when cutting through flame cut or out of
square pipe ends.
Use adequate feed, .003” to .006” (.08 mm to .15 mm) per revolution there-after, to
establish a continuous chip cut.
If the feed is too light, only light stringer chips will be removed.
If the feed is too heavy the drive will start to overload and the chip will start to have
a rough or torn appearance.
Stainless steel which work hardens, must be worked with a heavy enough feed to
stay under the work hardened surface (.003” to .006” (.08 mm to .15 mm) feed).
Never allow the Tool Bit to burnish the surface.
Reduced feed and speeds will normally minimize chatter problems.