Tri Tool 206B ID Tracking Module - Manual (Page 11)

11
ID Tracking Module for the Model 206B
92-0461 : Rev. 941005
NOTE:
Position the ID Tracking Module Assy so that the Tracking Wheel is in contact with
the ID of the pipe.
Tightly lock the Retaining Plates in place with the Hold Down Screws from the back
of the Base Plate.
Location of the Retaining Plates
Tighten the Spring Draw Rod, but leave enough travel to accommodate out of round
pipe.
Make sure the Travel Stop Set Screw is retracted back flush with the bottom
of the Spring Bracket.
Install the Tool Bits in the ID Tracking Module.
Install the Beveling Tool Bit with the cutting edge on the centerline of the pipe or
tube.
The Land thickness will be determined by the position of the Beveling Tool bit in the
slot.
Slide the Beveling Tool Bit up and down in the slot keeping the bottom of the Tool Bit
flat against the bottom of the slot.
Once the desired position has been achieved, then tighten all of the Set Screws
which make contact with the Tool Bit.
Install the Facing (Land) Tool Bit with the cutting edge to the outside of the Tool
Holder.