Tri Tool 206B ID Tracking Module - Manual (Page 8)

8
TRI TOOL INC.
92-0461 : Rev. 941005
WARNING:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
If the Model 206B-IDTM is operated in such a manner that the Tool Block collect
debris while cutting, the Tool Block and the Feed Screw should be cleaned after
each cutting operation.
Clean Up
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the Cutting Head during the machining operation are
removed.
RECOMMENDED MAINTENACE SCHEDULE
Daily maintenance when the unit is in operation:
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
Visually inspect for loose screws, missing screws, damage, etc.
After every 20 hours of actual operation:
Clean and lubricate the Slide Rails.
Disassemble the unit and wipe the Slide Rails.