Tri Tool 206B ID Tracking Module - Manual (Page 12)

12
TRI TOOL INC.
92-0461 : Rev. 941005
NOTE:
The Land width will be determined by the position of the Beveling Tool Bit in the slot.
Slide the Facing Tool Bit up and down in the slot keeping the bottom of the Tool Bit
flat against the bottom of the slot.
Once the desired position has been achieved, then tighten all of the Set Screws
which make contact with the Facing Tool Bit.
Attach the proper power supply line to the Model 206B.
Check that the Air Supply (FRL) is installed and set properly.
Turn the Motor on and start cutting.
Installing the Beveling Tool Bit