Tri Tool 224B ID Tracking Module - Manual (Page 14)

14
TRI TOOL INC.
92-0834 : Orig. 0990603
NOTE:
Stop the 224B drive motor.
Rotate the spring retracting cam to release the tracking wheel from the pipe.
Release the 224B from the pipe.
If the tool slide is loose on the base plate, re-adjust the gib using the adjustment
set screws. Loosen the lock nuts, then tighten the adjustment set screws so that
there is no play between the tool slide and the base plate, (the tool slide must
still move freely on the base plate) and secure in place with the locknuts.
Location of Retaining Plates