Tri Tool 304 Tube Squaring - Manual (Page 11)

11
Model 304 Tube Squaring Machine
92-0749 : Rev. 110328
NOTE:
NOTE:
OPERATION
Always read the operating instructions carefully/completely before attempting to
operate the Model 304 Tube Squaring Machine.
When operating any/all Tri Tool Inc. equipment follow the 'NOTE' statements through
the manual for equipment safety/warranty voids and ‘WARNING’ and/or ‘CAUTION’
notes for operator safety.
A FRL (Filter/Regulator/Lubricator) is required to protect the warranty on all TRI
TOOL INC. air or hydraulic driven tools.
The motor warranty is void if damage occurs from contaminated air or lack
of lubrication.
The FRL unit must be maintained as required. The frequency will depend on
the basic air supply. Keep the water trap drained, filter cleaned and the
lubricator oil reservoir filled so there's a drop of oil every two (2) to five (5)
seconds.
If the unit is to be left idle for 24 hours or more after being run on ‘wet’ air, it is
advisable to squirt oil directly into the air motor inlet and run the motor for two
(2) to three (3) seconds.
This will prevent rusting and ‘freezing’ of the rotor vanes.
For Hydraulic Motors refer to their ‘Operator’s Manual’ for specifics.
When the unit is operated in the vertical position, cutting head up, it should be
turned upside down and the chips and/or other debris removed after each cutting
operation has been completed.
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the cutting head during the machining operation are
removed.
Disassembly of the power unit voids the warranty, except when performed
by a TRI TOOL Inc. designated repair technician (Letter of designation is
required).The handle of the motor may be rotated to another position as
necessary to fit into some situations.