Tri Tool 304 Tube Squaring - Manual (Page 13)

13
Model 304 Tube Squaring Machine
92-0749 : Rev. 110328
NOTE:
Insert the tool bit(s) into the slot(s) in the Cutting Head.
The cutting edge of the tool bit(s) must be located on the radial centerline.
Do NOT install the tool bits backwards.
Tool Bit Tightening
Tighten the set screws to secure the tool bit(s) to the Cutting Head.
Adjust the counterbore tool bit radially to control counterbore diameter.
Adjust the bevel tool bit radially to control counterbore depth to the bevel relation-
ship.
Select the desired Saddle size for the pipe or tube to be worked on.
Reference the 'Saddle Sets' section.
Insert the upper Saddle half into the machine and thread the Saddle Locking Screw
into the Saddle.
Raise the top Saddle using the Saddle Handle Assembly.
Insert the lower Saddle half and snap into place.
Place the pipe or tube into the Saddles.
Verify a clearance of 1/8” (3 mm) between the tool bit(s) and the pipe or tube
face as held by the saddles.