Tri Tool 576AC Sever Machine - Manual (Page 11)

11
Model 576AC SEVERMASTER TM
92-0676 : Rev. 070222
OPERATION
Read the operating instructions carefully before attempting to operate the Model
576AC SEVERMASTER™.
INSERTING THE COLLET
Select the desired size collet for the pipe or tube to be worked on.
Raise the handle to release pressure on the adjust nut.
Rotate the adjust nut until the eyebolt can be raised out of the slot and then the
hinge bracket may be rotated back and down.
Remove the pusher sleeve from the main housing.
Remove the collet, if there is one, from the inside of the main housing.
Insert the correct collet into the main housing and then slide the pusher sleeve back
into the main housing and into contact with the collet.
Rotate the hinge bracket back up and let the eyebolt drop back into the slot.
Rotate the adjust nut on the eyebolt to secure in the slot.
MOUNTING THE TOOL HOLDER
Select the tool holder which will allow the tool bit to reach the work surface.
Place the tool holder in the tool holder slot.
Insert the (4) four cap screws that hold the tool holder in place.
Mount tool holder #1 for tube ranging from 4.50” (114.3 mm) to 6.625” (168.3 mm).
Mount tool holder #2 for tube ranging from 2.00” (50.8 mm) to 4.50” (114.3 mm).
MACHINING INSTRUCTIONS
Turn the motor on to full speed by depressing the lever.