Tri Tool 648RBL Clamshell Hydraulic 2 Piece - Manual (Page 15)

15
Model 648SB Low Profile Clamshell (2 Piece)
92-1146 : Rev. 131230
NOTE:
Tool Block Maintenance
Clean the Slide Rails, the Feed Nut, the Sprocket Assembly and the Feed
Screw.
Inspect these parts for damage and replace as required.
Lubricate and reassemble the Tool Block.
Use lubricant on the Feed screw sparingly or wipe to a film condition.
Excess lubricant will collect grit and/or chips and tend to cause thread
jamming and/or damage.
Adjust the Adjustable Slide Rail to provide a firm, but not excessive rotational
pressure on the Sprocket.
The Slide Rails must be overtightened to squeeze the oil into a thin film
against the male and female surfaces of the Slide Rails.
Reset for proper operation.
Clamshell Nomenclature
HOLD-DOWN
SCREWS
THRUST
PLATE
HEADSTOCK
MAIN
HOUSING