Tri Tool 648RBL Clamshell Hydraulic 2 Piece - Manual (Page 18)

18
TRI TOOL INC.
92-1146 : Rev. 131230
NOTE:
TRIPPER
SHAFT
ASSEMBLY
TRIPPER
LEVER
BALL PLUNGER
SET SCREW
TRIPPER
GUARD
SHOULDER
BOLT
Tripper Shaft Installation
Lubrication Recommendations
The Drive Gears require a high string lubrication grease such as ‘Chevron
Utility Grease’ (P/N 68-0020).
The Slide Rails and Tool Blocks require a light oil such as SAE 10 light
machine oil.
The Feed Screw for the Tool Block and the Tripper Block Assembly require a
SAE 10 light machine oil for normal conditions and under dusty conditions a
silicone, graphite or molybdenum disulfide ‘dry’ lubricant.
A light film of all-purpose grease may be used, but it must be checked for grit
contamination frequently.
The bearings in the Drive Motors are sealed and do not require any
lubrication.