Tri Tool 648RBL Clamshell Hydraulic 2 Piece User Manual
Page 26
26
TRI TOOL INC.
92-1146 : Rev. 131230
NOTE:
NOTE:
When the Tool Bits sever the pipe, disengage the Feed Pin and let the headstock
rotate two (2) to three (3) times to clear the chip.
Go back to paragraph 'Turn off the Hydraulic Motors by closing the Throttle Control
Valve' and proceed from there.
TOOL BIT ADJUSTMENT FOR PART OFF AND DOUBLE BEVEL
Install Tool Bits A, D and E into the Tool Blocks No. 1 along with two (2) spacers, S3
and S4.
Either Tool Block may be designated as No. 1.
Position the Spacers flush with the inside face of the Tool Holder.
Position Tool Bits D and E approximately 1/2” (12.7 mm) outward from the cutting
edge of Tool Bit A.
Tool Bits D and E will be repositioned to contact the beveled surface as the
cutting progresses.
Tighten the Set Screws holding Tool Bits A, D and E.
Install the Tool Bits B and C into Tool Block No. 2 along with the two (2) spacers S1
and S2.
Tool Bit with Land