Tri Tool 648RBL Clamshell Hydraulic 2 Piece User Manual
Page 24
24
TRI TOOL INC.
92-1146 : Rev. 131230
WARNING:
CAUTION:
When the Feed Pin to Sprocket engagement is not as shown above,
operation of the Clamshell may cause serious damage or destroy the Feed
Pin and/or the Sprocket.
Incorrect Alignment of the Feed Pin
Tripper Block Adjustment
When the Feed Pin to Sprocket engagement is as shown in the figure above then it
will be necessary to loosen the four (4) Cap Screws on the Tripper Bracket, so that
it may be adjusted to the proper gap, .020” (.51 mm) to .030” (.76 mm), required for
proper engagement.
Go back to 'Select and Install the Desired Tool Bit Set' located in the previous
information of this section.
Tool Bit Setup
Select the proper Tool Bit set.
Use of dull or improperly designed Tool Bits or Tool Bits not manufactured by
TRI TOOL Inc. may result in poor performance and may constitute abuse of
this machine and therefore voids the TRI TOOL Inc. factory warranty.
CAP SCREWS