Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 175)

V T 1 0 0 I n t e r f a c e 4-67
Static UDP Trans Table Screen
The Static UDP Trans Table screen (Figure 4.60) allows static mapping of
global UDP Server ports to a local host IP Address/port combination. The
parameters described below enable access to UDP Servers on the private/
corporate network “behind the NAT.” The parameters may be used only when
in NAPT mode.
Figure 4.60 Static UDP Translation Table Screen
Global Port Decimal IP Port exposed to the global Internet. Default is 0.
Server Port Decimal IP Port of the local UDP Server. This port is usually the same as the
Global Port. Default is 0.
Server Address IP Address of the local UDP Server. Default is 0.0.0.0.
The “Add New” prompt lets the user add additional addresses.
You can configure or change the above-listed parameters on the Static UDP
Trans Details screen (Figure 4.61), which is accessed by selecting the
appropriate <Ndx> number on the Static UDP Trans Table screen.
Figure 4.61 Static UDP Translation Details Screen