Visara Master Console Center Operations Guide - Manual (Page 37)

Chapter 3 Selecting Consoles
Operations Guide 37
Key Sequence Function
<ESC>&w13F Turn off display.
<ESC>&w6f<80,132>X Select number of columns.
<ESC>&x<0,1>C Turn off/on send cursor position mode.
<ESC>*d0E Normal display.
<ESC>*dQ Cursor on.
<ESC>*dR Cursor off.
<ESC>*d0Q Select underline cursor.
<ESC>*s^ Return terminal identity.
<ESC>*s<-1,-2,-3,-4>^ Return terminal capabilities.
<ESC>*y^ Return downloadable character set
capabilities.
Table 7. HP700/92 Console Emulation, Supported Command Key Sequences
Unsupported Features
This emulation does not support the following features.
ƒ Configuration menus for setting terminal modes.
ƒ Support for printers, modems, or other external devices.
ƒ Memory lock mode.
ƒ EM52, EM100, and EM220 mode commands.
ƒ Bell commands.
ƒ Cursors other than a non-blinking block cursor.
The following commands are not supported by this emulation.
Note: <ESC> indicates the escape key. <x>, <y>, and <z> are parameters
to commands:
Key Sequence Function
<ESC>@ Stop data transmission from the terminal
for one second.
<ESC>0 Copy terminal memory to selected
destination
<ESC>f Disconnect the modem.
<ESC>l Begin memory lock mode.
<ESC>z Initiate a self test of the terminal.