Watson-Marlow FC32 - Manual (Page 5)

OPERATOR’s MANUAL
FC32
FC32 OM 1.02 EN Version: 1.02 Page 5 of 10
3 General information
3.1 Unpacking and inspection
FlexCap 32 is a semiautomatic screw capping for bottles. By changing the screw head and bottle grip,
different bottles can be capped with different cap sizes.
Please check that all items listed on the packing list have been received, and that no items were
damaged during transport. In case of any defects or shortcomings, please contact Watson-Marlow
Flexicon or your local supplier immediately.
When ordering spare parts or accessories for the FlexCap 32, please state serial number. The serial
number is stamped on a label on the rear of FlexCap 32.
4 Installation
Fig. 4.1
Please check that, the machine is made for your local power supply. The sign on the machine
indicates the value of power (110/120 VAC or 220/240 VAC). The frequency has no influence.
If the delivered power cable does not match your plug, the power cable is mounted in the right plug.
The cable must be mounted as following:
Braun Phase
Blue Neutral
Yellow/Green Earth
Tab. 4.1
REMEMBER that the machine must always via the power plug be connected to the earth and
connected to CLEAN and DRY compressed air.
Due to the safety it is imperative that the earth connection is correctly established.
The plug box (E) contains 2 pieces of fuses. When the cover of fuse box is removed 1 more fuse is
found inside the machine.
Connect the 5-7 clean and dry compressed airs to the pipe stub (P). Connect the power to the plug
box (E) and the machine is ready for use.