WattMaster WCC III part 14 - Manual (Page 34)

WCC III Technical Guide 13B-32
13B. WCC III - MCD INSTALLATION GUIDE
12. The administration username will time out after 15
minutes, and you will be required to reenter the user
name and password again.
13. Type “sudo install-menu” at the wcciii@wcciii-mcd:~$
prompt to run this program. All of the selections require
root level permissions. The program menu will not run
without them.
14. NOTE: DO NOT run the install-menu program from
inside WebMin’s Command Shell. It will not work
there. This install-menu program is meant to work
only from telnet/ssh session or from the actual console
(i.e. USB keyboard and VGA monitor that is directly
connected to the WCCIII-MCD2)
The following menu screen should appear:
Please Pick a Function:
1. Setup New CrystalFontz 635 Display
2. Restore Backtask DAT Files from CompactFlash
3. Apply USB Over-Current HOTFIX and Reboot
4. Reset APCUPSD Server to Default Settings
5. Reset Webmin to Default Settings
6. Reset Firewall to Default Settings
7. Reset LCDd to Default Settings
8. Create New SSH Server Keys
9. Shutdown and Reboot MCD
16 Total Choices
Press ENTER (or “d”) to scroll downward
OR “u” to scroll upward (Type “quit” to quit)
PLEASE ENTER A CHOICE: ___
Install-Menu Program
How to Use the Initial Install and
Recovery Program on the WCCIII –MCD2
with the install-menu program
Obtain a VGA monitor and a USB keyboard to connect to the
WCCIII-MCD2 device. There is a standard VGA monitor 15
pin connector on the bottom of the WCCIII-MCD2 device for
connection to a VGA type monitor. There are four external USB
connectors on the bottom of the WCCIII-MCD2 device, and
you can use any one of these external USB ports for a keyboard
connection.
WattMaster Controls has developed an installation program for the
Linux command line interface, and this program is called install-
menu. This install-menu program has eleven sub-programs that
will allow for the following operations to be performed:
1. The setup of a new CrystalFontz 635 Display.
2. Application of the USB over-current HOTFIX.
3. Resetting the APCUPSD server to default settings.
4. Resetting the WebMin server to default settings.
5. Resetting the internal Linux Firewall to defaults.
6. Resetting the LCD display server to default settings.
7. Creating new SSH Server keys.
8. Shutdown and Reboot MCD.
9. The install-menu program is meant to be used to
the initial IP setting tool and BACKTASK data fi le
loading tool for the WCCIII-MCD2. For this to take
place, a monitor and keyboard needs to be connected
temporarily just for the initial IP setup and BACKTASK
data fi le loading.
10. The default administration username is wcciii and the
password is wt@@58.
11. This username and password are both CAP sensitive
and should be entered in lower case letters only.