ACTi KCM-5211E - Manual (Page 13)

www.acti.com
Hardware Manual
13
2. When done, close the back cover by tightening the three (3) screws.
3. Connect the other end of the Ethernet cable to a network switch.
NOTE: In case of using a non-PoE switch, you must use an external power adaptor (not
included) to connect the camera to a power source. See Connecting a Power Adaptor
(Optional) on page 15.
Micro SDHC Slot
Audio In /Out Jacks
12V Power Connector
Serial Connector
Digital Input / Output
(DI/DO) Connector