Prepare the power adaptor (optional), Er to, Prepare the – ACTi KCM-3911 User Manual
Page 10: Power adaptor (optional)
KCM-3911 Hardware Manual
Prepare the Power Adaptor (Optional)
The camera consumes 9.6W power when powered by a Power over Ethernet (PoE) switch
that is IEEE802.3af compliant. In case of using a non-PoE switch or your PoE switch has
limited power supply, you can purchase a power adaptor and directly connect the camera to a
power outlet. The power adaptor must be connected to the supplied terminal block before use.
To do this, follow the procedures below:
1.
Loosen the screws of the
12V
and
GND
pins of the power terminal block.
2.
Take note that a standard power adaptor cable has two (2) different wires:
3.
Connect the wire with the white stripe to the
12V
pin and the other to the
GND
pin.
White stripe: Connects to 12V Pin
Connects to GND Pin