Airmar WeatherCaster™ Software - Manual (Page 61)

61
5. Click Select File (see Figure 75). In the Open dialog box, browse to the sensor
flash file to be used. The file name will end in ”.ax”. Click Open.
6. When the Setup dialog indicates “READY to PROGRAM”, click the PROGRAM
button to perform the flash update. When the flash update has been completed,
there will be two status messages. The window will say “PROGRAMING
COMPLETE” followed by “EEPROM FORMATTING COMPLETE.”
Wait several seconds for the WeatherCaster software to establish
communication with the sensor. When you are finished updating the flash
memory in all sensors, click OK to go to a WeatherCaster display screen.
NOTE: If you are unable to update the flash, select a Baud Rate from the drop-
down menu and try again.
Figure 75. Advanced Setup window with Update Flash tab
and Open window