AML M7220 Wireless Terminal - Manual (Page 69)

2-43
USER’S GUIDE M7220 Wireless Hand-held Terminal
Host / Terminal Setup - cont’d.
General Settings
Section Setting Parameter Available Options Option Description
TN5250 Settings
Web Browser
Custom 1
Custom 2
RESET on Error
RESET Delay
Long Bar codes
Display Mode
Command
Pass IP as Param
Command
Pass IP as Param
1.) Manual
2.) Automatic
Min: 3 seconds
Max: 10 seconds
1.) Allow
2.) Truncate
1.) Text
2.) Graphics
(Text Entry)
Enabled/Disabled
(Text Entry)
Enabled/Disabled
The user must manually reset an error condition
The Software will automatically send a RESET
to the server after displaying the error
message for the amount of time specified in
RESET Delay
The amount of time to display an error
message until automatically sending a RESET
to the server
Allow long bar codes to automatically move to
the next input field
Truncate long bar codes to fit in the current
input field
Use the Web Browser in text only mode
Use the Web Browser in graphical mode
Linux command to run when selected in the
“Connect / Reconnect” menu
Enable/Disable passing the Host Server's IP
address (as set up in the Host Server menu) to
the Linux command as a normal parameter
Linux command to run when selected in the
“Connect / Reconnect” menu
Enable/Disable passing the Host Server's IP
address (as set up in the Host Server menu) to
the Linux command as a normal parameter
Section Available Options Option Description
Auto-Connect
Auto-Delay
Auto-Host
Out of Range
Automatically connect to a host on boot
Delay connection to allow network startup
Connect to selected host on boot
Give no warning upon moving out of range of current AP
Sound a beep upon moving out of range of current AP
Display a visual warning upon moving out of range of current AP
Enabled/Disabled
Min: 0 seconds
Max: 60 seconds
(Host List)
1.) No Warning
2.) Audio Warning
3.) Visual Warning