Eneo VKC-900IR36 - Manual (Page 4)

3
DE
EN
Hardware Connection
Power and Video Cables
‎Figure 2-1 shows the power and video cables.
Power and video cables
Connect the BNC connector of the power or video cable to a video signal cable and
connect the other connector to a low-voltage power cable (12 V DC). After installing
the camera, directly connect the video cable and power cable.
The BNC video output interface is used to emit composite video signals. Monitors
with a resolution of higher than 800 TVL are recommended.
Function Keys
A user can call OSD main menus through multi function switch control keys, and
check and set camera parameters.
Figure 2-2 shows the camera function keys.
OSD menu control key: It is used to enter OSD menus or select menu items when
you press this key in the middle of the multi function switch.
Figure 2-1
Figure 2-2