Eneo VKC-900IR36 - Manual (Page 8)

7
DE
EN
Device Installation
1. Open a package, take out the camera, and unscrew the camera shell, as
show in Figure 5-1. Unscrew the camera shell
2. Take out the positioning label delivered with the camera and drill three holes
with diameter of 5.5mm on the ceiling or wall based on the marks on the positi-
oning label, nail swell plastic buttons into drilled holes, as shown in Figure 5-2.
Stick the positioning label
3. Connect the multi-connector cable and fix the camera to the ceiling(or wall)
by use of self-tapping screws.
4. Loosen the direction focusing screw, position left-right up/down to adjust
the angle of the camera that the camera faces the monitored area, then fix the
direction focusing screw, as shown in Figure 5-3.
Adjust the camera direction.
Figure 5-1
Figure 5-2
Figure 5-3