H3C Technologies H3C S10500 Series Switches User Manual
Page 13
12
# Upgrade the BootWare of the standby MPU in slot 1 of member device 1 (upgrade other standby
MPUs in the same way).
<Sysname>bootrom update file chassis1#slot1#flash:/mpu.btw chassis 1 slot 1
This command will update bootrom file on the specified board(s), Continue? [Y/N]:y
Now updating bootrom, please wait...
Start accessing bootflash chip...
Bootrom update succeeded in chassis 1 slot 1.
# Upgrade the BootWare of the LPU in slot 3 of member device 2 (upgrade other LPUs in the same way).
<Sysname>bootrom update file flash:/lpu.btw chassis 2 slot 3
This command will update bootrom file on the specified board(s), Continue? [Y/N]:y
Now updating bootrom, please wait...
Start accessing bootflash chip...
Bootrom update succeeded in chassis 2 slot 3.
# Upgrade the BootWare of the switching fabric module in slot 6 of member device 2. (upgrade other
switching fabric modules in the same way).
<Sysname>bootrom update file flash:/lpo.btw chassis 2 slot 6
This command will update bootrom file on the specified board(s), Continue? [Y/N]:y
Now updating bootrom, please wait...
Start accessing bootflash chip...
Bootrom update succeeded in chassis 2 slot 6.
# Reboot the IRF fabric to validate the upgrade.
<Sysname> reboot
Start to check configuration with next startup configuration file, please wait.
........DONE!
This command will reboot the device. Continue? [Y/N]:y
Reboot device by command.
2.
Upgrade system software
# Specify the file newest.bin as the main system software image to be used at the next startup of the
active MPU of the IRF fabric.
<Sysname> boot-loader file newest.bin chassis 1 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 0!
# Specify the file newest.bin as the main system software image to be used at the next startup of the
standby MPUs of the IRF fabric.
•
On the standby MPU in slot 1 of member device 1
<Sysname> boot-loader file chassis1#slot1#flash:/newest.bin chassis 1 slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 1!
•
On the standby MPU in slot 0 of member device 2
<Sysname> boot-loader file chassis2#slot0#flash:/newest.bin chassis 2 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 2
slot 0!
•
On the standby MPU in slot 1 of member device 2