Connecting the power cord – H3C Technologies H3C S5130 Series Switches User Manual
Page 21
14
4.
Grasp the handle of the power module with one hand and pull the module part way out. Support
the module bottom with the other hand, and pull the power module slowly along the guide rails out
of the slot.
5.
Place the removed power module in an antistatic bag.
Figure 20 Removing a PSR150-A power module
Connecting the power cord
CAUTION:
•
Provide a circuit breaker for each power cord.
•
Before connecting the power cord, make sure the circuit breaker on the power cord is turned off.
Table 4 Power cord connection procedures at a glance
Switch model
Available power source
Connection procedure
reference
•
S5130-28S-EI
•
S5130-28S-PWR-EI
•
S5130-28TP-EI
AC power source
Connecting the switch to an AC
power source
•
S5130-52S-EI
•
S5130-28F-EI
•
S5130-52TP-EI
AC power source
Connecting the switch to an AC
power source
–48 V DC power source in the
equipment room
Connecting the switch to a –48
VDC power source
RPS (recommended H3C models:
RPS800-A and RPS1600-A)
Connecting the switch to an RPS
•
S5130-28S-HPWR-EI
•
S5130-28TP-PWR-EI
•
S5130-52S-PWR-EI
•
S5130-52TP-PWR-EI
AC power source
Connecting the switch to an AC
power source
H3C RPS1600-A
Connecting the switch to an RPS
The S5130-28F-EI switch provides two power module slots. The PSR150-A1, PSR150-A, and PSR150-D1
power modules are available for the S5130-28F-EI switch. The PSR150-A1 and PSR150-A power modules