H3C Technologies H3C SR8800 - Manual (Page 349)

333
Step Command Remarks
8. Configure the maximum
number of redistributed Level
1/Level 2 IPv6 routes.
ipv6 import-route limit number Optional.
9. Configure the filtering of
outgoing redistributed
routes.
ipv6 filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name | route-policy
route-policy-name } export [ protocol
[ process-id ] ]
Optional.
Not configured by
default.
10. Enable route leaking.
ipv6 import-route isisv6 level-2 into level-1
[ filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name | route-policy
route-policy-name } | tag tag ] *
Optional.
Not enabled by default.
11. Specify the maximum
number of equal-cost load
balanced routes.
ipv6 maximum load-balancing number
Optional.
By default, load
balancing is disabled.
NOTE:
•
The ipv6 filter-policy export command is usually used in combination with the ipv6 import-route
command. If no
protocol is specified for the ipv6 filter-policy export command, routes redistributed
from all routing protocols are filtered before advertisement. If a protocol is specified, only routes
redistributed from the routing protocol are filtered for advertisement.
• For information about ACL, see ACL and QoS Configuration Guide.
• For information about routing policy and IPv6 prefix list, see the chapter “Configuring routing policies.”
Configuring BFD for IPv6 IS-IS
Bidirectional forwarding detection (BFD) provides a mechanism to quickly detect the connectivity of links
between IPv6 IS-IS neighbors, thus to improve the convergence speed of IPv6 IS-IS.
To configure BFD for IPv6 IS-IS:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable an IS-IS process and
enter IS-IS view.
isis [ process-id ] N/A
3. Configure the network entity
title for the IS-IS process.
network-entity net Not configured by default
4. Enable IPv6 for the IS-IS
process.
ipv6 enable Disabled by default
5. Return to system view. quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable IPv6 for an IS-IS
process on the interface.
isis ipv6 enable [ process-id ] Disabled by default
8. Enable BFD on the interface. isis ipv6 bfd enable Not enabled by default