H3C Technologies H3C SR8800 - Manual (Page 44)

28
Task Remarks
Configuring RIP route
control
Configuring an additional routing metric Optional
Configuring RIPv2 route summarization Optional
Disabling host route reception Optional
Advertising a default route Optional
Configuring inbound/outbound route filtering Optional
Configuring a priority for RIP Optional
Configuring RIP route redistribution Optional
Tuning and optimizing
RIP networks
Configuring RIP timers Optional
Configuring split horizon and poison reverse Optional
Configuring the maximum number of load
balanced routes
Optional
Enabling zero field check on incoming RIPv1
messages
Optional
Enabling source IP address check on incoming RIP
updates
Optional
Configuring RIPv2 message authentication Optional
Specifying a RIP neighbor Optional
Configuring TRIP Optional
Configuring RIP-to-MIB binding Optional
Configuring the RIP packet sending rate Optional
Configuring RIP FRR Optional
Configuring BFD for RIP
Single-hop detection in BFD echo packet mode Optional
Bidirectional detection in BFD control packet mode Optional
Configuring RIP basic functions
Configuration prerequisites
Before you configure RIP basic functions, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for interfaces, and make sure that all neighboring routers are reachable to
each other.
Configuration procedure
Enabling RIP and a RIP interface
To enable RIP: