H3C Technologies H3C SR8800 - Manual (Page 20)

14
Figure 2 Schematic diagram for the internal interface
When configuring ACFP on an OAP module, to ensure the normal communication between the router
and the OAP module, you must configure the connection mode for the OAP module internal interface as
extend.
To configure the connection mode for an internal interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter internal interface
view.
interface interface-type
interface-number
N/A
3. Configure the connection
mode for the internal
interface.
port connection-mode { extend |
normal }
normal by default.
NOTE:
•
For more information about the port connection-mode command, see Layer 2—LAN Switching
Command Reference.
• When you disable the ACSEI function or change the connection mode for an internal interface, to avoid
disrupting the traffic, perform the operation on the ACFP client first, and then on the ACFP server.
• Spanning Tree Protocol (STP) cannot be enabled on the internal interface of an IM-IPS or IM-ACG card.
For more information about STP, see
Layer 2—LAN Switching Configuration Guide.
Enabling the ACFP trap function
To make ACFP work normally, you must enable the router to send traps of the ACFP module.
After the trap function on the ACFP module is enabled, the ACFP module will generate traps to report
important events of the module. The levels of the ACFP traps are described in Table 1 .
Table 1 ACFP trap message level
Trap message Level
Context ID type changed notifications