H3C Technologies H3C MSR 50 - Manual (Page 25)

17
Step Command Remarks
26. Set the delay timer for the
backup function to take
effect on system startup.
standby timer startup seconds
Optional.
30 seconds by default.
Displaying and maintaining interface backup
Task Command Remarks
Display statistics about the traffic
on the active interfaces enabled
with load balancing.
display standby flow [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Display the state information of the
active and standby interfaces. display standby state [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Interface backup configuration examples
Multi-interface backup configuration example
Network requirements
Use interfaces Serial 2/1 and Serial 2/2 on Router A to back up the active interface Serial 2/0,
assigning interface Serial 2/1 a higher priority, and configure switchover delays.
Figure 7 Network diagram
Configuration procedure
1. Configure IP addresses:
Follow
Figure 7 to configure the IP address and subnet mask for each interface. (Details not
shown.)
2. Configure a static route:
# On Router A, configure a static route to the segment 192.168.2.0/24 where Host B resides.
<RouterA> system-view
[RouterA] ip route-static 192.168.2.0 24 serial 2/0