Verifying the configuration – H3C Technologies H3C MSR 50 User Manual
Page 48
40
[RouterA] track 1 bfd echo interface ethernet 1/1 remote ip 1.1.1.2 local ip 1.1.1.1
3.
Configure VRRP on Router A:
# Create VRRP group 1, and configure the virtual IP address of the group as 192.168.0.10.
Configure the priority of Router A in VRRP group 1 as 110, and configure VRRP group 1 to monitor
the status of track entry 1. When the status of the track entry becomes Negative, the priority of
Router A decreases by 20.
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] vrrp vrid 1 virtual-ip 192.168.0.10
[RouterA-Ethernet1/2] vrrp vrid 1 priority 110
[RouterA-Ethernet1/2] vrrp vrid 1 track 1 reduced 20
[RouterA-Ethernet1/2] return
4.
Configure VRRP on Router B:
# Create VRRP group 1, and configure the virtual IP address of the group as 192.168.0.10.
<RouterB> system-view
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] vrrp vrid 1 virtual-ip 192.168.0.10
[RouterB-Ethernet1/2] return
Verifying the configuration
# Display detailed information about the VRRP group on Router A.
<RouterA> display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Ethernet1/2
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 192.168.0.10
Virtual MAC : 0000-5e00-0101
Master IP : 192.168.0.101
VRRP Track Information:
Track Object : 1 State : Positive Pri Reduced : 20
# Display information about track entry 1 on Router A.
<RouterA> display track 1
Track ID: 1
Status: Positive
Duration: 0 days 0 hours 0 minutes 32 seconds
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
BFD session:
Packet type: Echo
Interface : Ethernet1/1
Remote IP : 1.1.1.2
Local IP : 1.1.1.1