H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 95
86
[AC-mvlan-10] port WLAN-ESS 1
[AC-mvlan-10] quit
4.
Configure AC (for the WX6000 series access controller module)
# Enable IGMP snooping globally on the configuration interface of the switch that is installed with
the WX6000 series AC module.
<Device> system-view
[Device] igmp-snooping
[Device-igmp-snooping] quit
# Create VLAN 10, assign GigabitEthernet 0/0/1 to VLAN 10, and enable IGMP snooping in this
VLAN.
[Device] vlan 10
[Device-vlan10] port GigabitEthernet 0/0/1
[Device-vlan10] igmp-snooping enable
[Device-vlan10] quit
# Configure GigabitEthernet 0/0/2 as a trunk port, and configure it to allow packets from VLAN
2, VLAN 3, and VLAN 10 to pass.
[Device] interface GigabitEthernet 0/0/2
[Device-GigabitEthernet0/0/2] port link-type trunk
[Device-GigabitEthernet0/0/2] port trunk permit vlan 2 3 10
[Device-GigabitEthernet0/0/2] quit
# Log in to the configuration interface of the WX6000 series AC module on the switch using the
oap command, and enable IGMP snooping globally. Create VLAN 10, and enable IGMP
snooping in this VLAN.
<Device> oap connect slot 2
Press CTRL+K to quit.
Connected to OAP!
User interface aux0 is available.
Press ENTER to get started.
<AC> system-view
[AC] igmp-snooping
[AC] vlan 10
[AC-vlan10] igmp-snooping enable
[AC-vlan10] quit
# Configure Ten-GigabitEthernet 2/0/1 as a trunk port, and configure it to allow packets from
VLAN 2, VLAN 3, and VLAN 10 to pass.
[AC] interface Ten-GigabitEthernet 2/0/1
[AC-Ten-GigabitEthernet2/0/1] port link-type trunk
[AC-Ten-GigabitEthernet2/0/1] port trunk permit vlan 2 3 10
[AC-Ten-GigabitEthernet2/0/1] quit
# Configure VLAN 2, VLAN 3, and WLAN-ESS 1 on AC. Configure WLAN-ESS 1 as a hybrid port
with VLAN 10 as the default VLAN, and configure the port to permit packets from VLAN 2, VLAN
3, and VLAN 10 to pass and untag the packets.
[AC] vlan 2
[AC-vlan2] vlan 3
[AC-vlan3] quit
[AC] interface WLAN-ESS 1