H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 21)

13
The following describes how VFs are created on the routers in a VRRP group:
1. The master assigns virtual MAC addresses to all routers in the VRRP group. Each member router
creates a VF for this MAC address and becomes the owner of this VF.
2. Each router advertises its VF information to the other member routers.
3. After receiving the VF advertisement, each of the other routers creates the advertised VF.
Eventually, every member router maintains one VF for each virtual MAC address in the VRRP group.
VF weight and priority
The weight of a VF indicates the forwarding capability of a router. A higher weight indicates a higher
forwarding capability. When the weight is lower than the lower limit of failure, the router cannot forward
packets.
The priority of a VF determines the VF state. Among the VFs created on different member routers for the
same virtual MAC address, the VF with the highest priority, known as the active virtual forwarder (AVF),
is in active state to forward packets, and all other VFs listen to the state of the AVF and known as the
listening virtual forwarders (LVFs). VF priority ranges from 0 to 255, where 255 is reserved for the VF
owner. When the weight of a VF owner is higher than or equal to the lower limit of failure, the priority of
the VF owner is 255.
The priority of a VF is calculated based on its weight:
• On the router that owns the VF, if the weight of the VF is higher than or equal to the lower limit of
failure, the priority of the VF is 255.
• On a router that does not own the VF, if the weight of the VF is higher than or equal to the lower limit
of failure, the priority of the VF is weight/(number of local AVFs +1)
• If the weight of the VF is lower than the lower limit of failure, the priority of the VF is 0.
VF backup
The VFs corresponding to a virtual MAC address on different routers in the VRRP group back up one
another.
Figure 9 VF information